Publicité
Les langues disponibles
Les langues disponibles
Field Controls (OVD) oil vent damper reduces off cycle losses through oil fired heating appliances. When the
appliance is in a standby mode, heat escapes up the chimney. The heat comes from the appliance and the
conditioned space. To significantly reduce these losses, install a Field Controls Oil Vent Damper. The damper is
installed in the vent system between the draft control and chimney. The WMO-1 blocked vent safety shut off
installs between the draft control and appliance. When properly installed, the damper opens before the burner fires
and closes after the burner shuts off.
WARNING: The Oil Vent Damper CANNOT be used on an appliance that employs a constant burning
pilot.
The Field Controls Oil Vent Damper MUST be installed by a qualified agency in accordance with the
manufacturer's installation instructions.
The definition of a qualified agency is: any individual, firm, corporation or company which either in person or
through a representative is engaged in, and is responsible for, the installation and operation of oil appliances, who
is experienced in such work, familiar with all the precautions required, and has complied with the requirements of
the authority having jurisdiction. The oil vent damper is designed to service one appliance only.
AFTER INSTALLATION, THESE INSTRUCTIONS MUST REMAIN WITH THE EQUIPMENT FOR SERVICE OF THE APPLIANCE.
CAUTION
Before installing the oil vent damper system:
1.
Read this manual carefully and completely.
2.
Be sure to follow all procedures and safety inspections.
3.
Do not over ride the action of any safety or operational controls.
OIL VENT DAMPER SYSTEM
Model: OVD - 4 through 8
Items Included:
1) Oil Vent Damper Assembly
1) WMO-1 with gasket
1) Wiring Harness
Listed to UL-17 Standard and CSA B140.14
DO NOT DESTROY
2630 Airport Road · Kinston, NC 28504
Phone: 252-522-3031· Fax: 252-522-0214
www.fieldcontrols.com
Tape Plug
Here
Publicité
