Vortice ME 100/4 ES Livret D'instructions page 30

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
ENGLISH
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the elements (rain,
sun, etc.).
• Regularly inspect the appliance for visible defects.
If any faults are found, do not operate the appliance
but contact a Vortice authorised Technical Support
Centre immediately.
• If the appliance malfunctions and/or develops a
fault, contact a Vortice authorised Technical
Support Centre immediately. Ensure that only
genuine original Vortice spares are used for any
repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by a Vortice
Authorised Technical Support Centre.
• The electrical system to which the appliance is
connected must conform to applicable standards.
• The appliance is double insulated and therefore
does not need to be earthed.
• Connect the appliance to the electrical power
supply/socket only if the rated power of the supply
is sufficient to match the maximum rated power of
the appliance. If not, contact a professional
electrician without delay.
• Switch off the system's main switch:
a) if the appliance does not function correctly;
b) before cleaning the outside of the appliance;
c) if you decide not to use the appliance for any
length of time.
The appliance must be installed by a professionally qualified
electrician.
A multi-pole switch must be used to install the appliance. The
contact opening gap must be no less than 3 mm.
30
• The room must have an adequate source of
replacement air for this appliance to function
effectively. In the event that other non-sealed
combustion based appliances (such as water
heaters, gas stoves, etc.) are installed in the same
room, check that air replacement is sufficient for all
appliances to work effectively together.
• The appliance must either exhaust directly to the
outside or into a short duct (max 400 mm to ensure
the certified technical data). Efficiency losses will
occur if the appliance is installed in ducting subject
to any appreciable level of back pressure.
• The appliance cannot be used to control water
heater switches, heaters, etc.; neither must it expel
air into the hot air ducts of such appliances.
• The air or fumes to be extracted from the room
must be clean (i.e. free of grease, soot, chemical
and corrosive agents, and explosive or flammable
mixtures) and must not exceed a temperature of
50°C (122°F).
• Keep the appliance's intake and outlet grilles free to
ensure an optimum flow of air.
• Specifications
for
correspond to the electrical data on ID plate A
(Fig.1)
the
power
supply
must

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Me 120/5 es

Table des Matières