Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000284-001.book Page 19 Tuesday, November 21, 2017 12:14 PM
Adjustments.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Adjusting the wheel guard (figure 7).
Release clamping lever.
Turn the wheel guard to the requested work-
ing position, then clamp the wheel guard with
the clamping lever.
Allow the clamping lever to engage.
Illumination (figure 8).
Never look or stare into the
WARNING
light of the power tool's lamp
from a short distance. Never point the light of
the lamp into the eyes of other persons in
close vicinity. The radiation produced by the
lamp can be harmful for the eye.
When pressing the On/Off switch, the light is
switched on.
After releasing the On/Off switch, the light
briefly stays on and then switches off auto-
matically.
Fig. 7
1.
2.
Fig. 8
en
19
Clamping lever
=
=
Publicité
