Operation - Klarstein GRAZ Mode D'emploi

EN
12

OPERATION

Control Panel and Button Functions
Thermostat control knob: Adjust to maintain room temperature
1
Flame switch: Switches flame effect and power on/off
2
3 Low heating setting: please press (I) for 1000 W
High heating setting: please press (I) and (II) at the same time for 2000 W. Note:
4
Can not operate without first press (II).
Flame dimmer control: Adjust to set flame intensity
5
Note on Overheating Protection
If the heater stops working, turn the heater off and inspect the blockage of inlet or outlet.
Disconnect the plug and wait at least 10 minutes for the protection system to reset before
attempting to restart the heater. If the safe device still switches the heater off and makes
the heater fail to operate, take the heater to your nearest service center for examination
or repair.
Attention: before restarting the heater, the plug must be disconnected for at least 10
minutes