hestan Aspire ERS24 Mode D'emploi page 8

INSTALLATION
Reversing the Door Swing
Tools needed: Flathead screwdriver, Phillips screwdriver
EN
IMPORTANT: Before you begin, unplug the refrigerator or disconnect power.
Note that the handle does not need to be removed to reverse the door swing.
To remove door from hinges:
1. Using a flathead screwdriver, separate the hinge axis from Hinge 1. Set aside.
2. Open the door about 20° around the axis of Bottom Hinge 2, then lift the door off Bottom
Hinge 2 and set door aside.
3. Remove the right latch hook located in the right bottom of the door and plastic cap located
in the left bottom of the door.
4. Install the left latch hook (in accessory bag) to the left bottom of the door where the plastic
cap was placed and put the plastic cap on the other side.
To replace door on hinges:
1. Using a flathead screwdriver, remove the plug buttons from the screw holes opposite the
door hinges, top and bottom. Set aside.
2. Replace the axis on the Hinge 1 and tighten it firmly. Remove Hinge 1 and install it with left
latch block (in accessory bag) on the opposite bottom side.
3. Remove Hinge 2 and take down the right latch block, place Hinge 2 on the opposite top side.
Separate the axis from Hinge 2 and set it aside.
4. Align the door on Bottom Hinge 1 and replace axis on Hinge 2. Tighten it firmly.
5. Push the plug buttons into the original screw holes.
7
©2020 Hestan Commercial Corporation
(continued)
Cabinet
Door
Door
Left latch hook
Door limit
Hinge axis
Hinge 1
Hinge 2
Left latch block
Right latch hook
Hinge 2
Hinge 1
Right latch block