Cleaning And Maintenance - hestan Aspire ERS24 Mode D'emploi

OPERATING YOUR REFRIGERATOR
(continued)
These racks are designed to only be pulled out 1/3 of the way. This is a safety feature so that the
refrigerator will not tip over or let the shelf fall out.
EN
The racks are removable and reversible. To remove a rack, take out the cans on the rack and pull it
out until it stops. Then lift up the front of the rack and remove it from the unit. Use these steps in
reverse to reinstall the shelf.

CLEANING AND MAINTENANCE

Cleaning the Outside Cleaning the Outside
Unplug your Refrigerator. Clean the outside with a cloth dampened in mild soapy water. Dry
thoroughly with a soft cloth. Polish with a stainless steel cleaner. To clean the door gasket, use
only mild soapy water. Never use harsh cleansers or scouring pads to clean any part of your unit.
Cleaning the Inside Cleaning the Inside
Unplug your Refrigerator and remove its contents. Rinse the inside surfaces with plain water and
dry the chrome racks and shelving. Avoid getting excess water inside the machine since it will flow
into the water trap near the compressor and possibly overflow.
Defrosting the Unit Defrosting the Unit
The unit incorporates an automatic defrost system in which the refrigerated surfaces of the unit
defrost automatically. Defrost water drains into a hole in the floor of the storage compartment and
is channeled into a drain pan located at the back of the unit near the compressor. Heat transferred
from the compressor evaporates any water that has collected in the pan. Be sure the drain hole in
the floor of the unit is clear and unobstructed.
Extended Non-Use Extended Non-Use
VACATION/HOLIDAY, PROLONGED SHUTDOWN VACATION/HOLIDAY, PROLONGED SHUTDOWN
The following steps are recommended for periods of extended non-use:
Remove all customable content from the unit.
Disconnect the power cord from its outlet/socket and leave it disconnected until the unit is
returned to service.
If ice is on the evaporator, allow ice to thaw naturally.
Clean and dry the interior of the unit. Ensure all water has been removed from the unit.
The door must remain open to prevent formation of mold and mildew. Prop open the door at a
minimum of 2" [50 mm] to provide the necessary ventilation.
WINTERIZATION WINTERIZATION
If the unit will be exposed to temperatures of 40°F [4°C] or less, the steps above must be followed.
10
©2020 Hestan Commercial Corporation