hestan Aspire ERS24 Mode D'emploi page 3

IMPORTANT SAFEGUARDS
Read all instructions before using this appliance. Use this appliance only for its intended purpose
as described in this instruction manual. Always exercise basic safety precautions, as described
below. After reading the instruction manual, store it in an accessible place where the user(s) of
this product can easily find it.
The purpose of these safety precautions is to ensure safe and correct use of the product
to minimize risks that could cause serious damage and injury to you or others. The safety
precautions are divided into WARNINGS and CAUTIONS. Cases where improper handling of the
unit could lead to death or serious injury are listed under the WARNING heading. However, the
cases listed under CAUTION could also lead to serious results. To ensure safety, adhere strictly
to both types of safety precautions.
1. All repairs, disassembly and modifications should be performed only by qualified technicians.
Attempting to perform these yourself could result in fire, malfunction or injury.
2. Never splash water directly onto the product or wash it with water without unplugging, as a
short circuit could result. In a rainy environment, a water-proof covering is recommended.
3. Never put flammable or volatile substances into the unit as explosion and fire could result.
4. Do not damage, modify, excessively bend, strain, twist or bundle the power cord. Avoid hot,
sharp, or aggressive surfaces. Also, placing heavy objects on the power cord or binding it
could damage the cord, possibly resulting in electrical shock or fire.
5. Use a dedicated wall outlet. Do not use an extension cord or multiple-outlet adaptor as this
could result in electrical shock, overheating and fire.
6. Never use flammable spray cans or leave flammable substances near the unit. Sparks from
electrical switches could result in explosion or fire. If a combustible gas is present near the
appliance, turn off the source of the gas, then open the windows and doors to allow the gas
to dissipate. To avoid an explosion, do not pull the plug or switch off the unit.
7. The electrical socket used must have good grounding. The ground wire cannot be connected
with a gas pipe, heating pipe, water pipe, telephone line or lightning rod. It cannot be
replaced with the neutral wire of single-phase power. In addition to the ground wire, an
electrical leakage circuit breaker is also required.
8. Use an electrician installed ground fault circuit interrupter (GFCI) electrical outlet. If no GFCI
is installed, electrical shock could result.
9. Never climb onto the unit. The unit could tip over or fall and cause material damage or
personal injury.
10. Disconnect the power cord plug from the wall outlet before moving the unit and make sure
that the power cord is not damaged during transport. A damaged power cord could result
in electrical shock and/or fire.
11. Never unplug the unit by pulling on the power cord. Always grip the plug firmly and pull
straight out from the outlet. Pulling the cord could cause wire breakage, possibly resulting in
overheating and fire.
12. Repair or replace any cord that is frayed or damaged. Do not use a cord that shows cracks or
abrasions along its length.
1. This unit must be properly installed in accordance with the installation instructions along with
all local codes before it is used. See grounding instructions in the Installation section.
©2020 Hestan Commercial Corporation
EN
2