Troubleshooting - hestan Aspire ERS24 Mode D'emploi

TROUBLESHOOTING

Unit does not turn on Unit does not turn on
Not plugged in.
EN
Fuse blown or circuit breaker tripped.
Press Power Button on control panel.
Noise or vibration Noise or vibration
Check that unit is level. If not, adjust leveling legs.
Unit is too warm Unit is too warm
Check that door is properly closed and sealed.
Check temperature setting. (To change the temperature setting, follow the steps in the
Operating
Check if door has been opened frequently or recently filled with product.
Unit Develops Condensation on External Surfaces Unit Develops Condensation on External Surfaces
Check the unit is properly exposed to excessive humidity. Moisture will dissipate as humidity
levels decrease.
Temperature Window displays "EI" Temperature Window displays "EI"
This message is an ALARM MODE indication. It indicates that thermostatic sensor has
malfunctioned. Contact your authorized service facility for sensor replacement.
Temperature Window displays "LI" Temperature Window displays "LI"
This message is an ALARM MODE indication. It indicates that the actual temperature is much
lower than your set temperature.
Temperature Window displays "HI" Temperature Window displays "HI"
This message is an ALARM MODE indication. It indicates that the actual temperature is much
higher than your set temperature. Possible causes are:
• The door might not be fully closed.
• The refrigerant may have leaked.
• The unit may have been recently loaded with room temperature product.
• The control panel may not be functioning properly and should be replaced. If you are
certain that the door is not the cause of the problem, contact your authorized service
facility immediately.
11
©2020 Hestan Commercial Corporation
Your Refrigerator section of this manual.)