Control Panel; Energy-Saving Tips; Installation - hestan Aspire ERS24 Mode D'emploi

CONTROL PANEL

Compressor Run Indicator
Power Set Button
Switch

ENERGY-SAVING TIPS

• Do not place the unit next to a heating vent, a range or in direct sunlight.
• Keep the door closed as much as possible, especially in hot, humid weather.
• Cover foods to reduce moisture buildup inside the appliance.

INSTALLATION

Remove the exterior and interior packaging. Use a soft dry cloth to wipe down the outside of
the refrigerator thoroughly. Use a clean cloth dampened with lukewarm water to wipe down the
inside of the refrigerator.
The unit should be located in a well-ventilated area. Avoid placing it near any source of heat or
moisture, or in direct sunlight. Direct sunlight may affect the finish, and nearby heat sources will
cause higher electrical consumption.
The Refrigerator is designed to be either free-standing or built-in. It has motorized fans at the
back of the unit that direct compressor-generated heat away from the compressor and through
the front of the unit. Keep the front vents unobstructed. If the unit is built-in, allow minimum
clearances of 1/4" [6 mm] at the sides, 1/2" [13 mm] at the back and 1" [25 mm] at the top.
Once the Refrigerator is positioned, the adjustable legs should be turned to level the appliance.
This will reduce vibrations.
Fahrenheit Scale Indicator
Temperature Display
Light Alarm
On/Off Indicator
Centigrade Scale Indicator
Up/Down
Buttons
©2020 Hestan Commercial Corporation
EN
Temperature
Unit Button
6