Battery Insertion / Replacement - Oakton 35625-40 Mode D'emploi

Figure 16
Figure 17
Probe Replacement
The modular probe of the food safety ther-
mometer is replaceable. To replace probe,
extend the probe partially to access the rubber
caps. Carefully pry up the rubber caps using a
pin, and remove the cap using a #2 Phillips
screws as shown. Grasp the probe and care-
fully separate the old probe from the probe
base. Install the new probe in the reverse
order, firmly tightening the screws and replac-
ing the rubber plugs. The calibration accuracy
of the unit is not affected by probe replace-
ment (Figure 16).
Battery Insertion and Replacement
To install a new 9V battery, remove the rubber-
ized battery compartment "plug" at the base of
the unit by grasping the sides of the cover and
pulling straight out, exposing the battery. Gently
shake or tap the base of the unit on your palm
to gain access to the battery. The 9V battery of
the unit is connected to the polarized snap
connector (Figure 17).
Note: Each time the battery is installed
or replaced, the temperature scale will default
to the ºC or Celsius scale. To select the ºF or
Fahrenheit scale see 'Setting/Changing ºC
and ºF Temperature Scales'.
Troubleshooting
Code: --- (on display)
Problem: Target temperature is over or
under range
Action: Select target within range specifications
19