Zigo Leader Manuel De Montage Et D'utilisation page 66

1. Release top and bottom Barrel Adjustor Locking Nuts to allow for Barrel
Adjustor movement. Turn counterclockwise.
2. Move top and bottom Barrel Adjustors inward by turning clockwise. Turn both
Barrel Adjustors evenly and test for Rear Wheel fit every 2 or 3 turns.
3. After installing Rear Wheel, turn Barrel Adjustor Locking Nut clockwise to lock
Barrel Adjustor in place.
10.2.2 Front Brake Lever (left lever on Cycle) and Brake Arm may not spring
back to unengaged position
This occurs when there is slack in any of the Brake Lines. Excess slack is most
likely to occur on ChildPod® between base of LeaderLink® Post (located near
Steering Interface) and hub.
1. Uncouple Cycle from ChildPod®. Pull back Brake Arms to ensure that they
have each returned to the unengaged position.
2. Turn ChildPod® on its side. Check all Brake Lines for slack in Cable Housing.
3. Once the slack Brake Line is identified:
a. Turn its Barrel Adjustor Locking Nut counterclockwise to allow for Barrel
Adjustor movement.
b. Remove Brake Line slack by turning Barrel Adjustor of slack Cable Line
counterclockwise. Do not overtighten Barrel Adjustor. See Section 2.2.1 of
Additional Instructions if you overtighten.
c. Lock Barrel Adjustor Locking Nut by turning clockwise.
d. Couple Cycle to ChildPod® and check Front Brake lever action.
66
Barrel Adjustor Locking Nut
Barrel Adjustor
Brake Arm disengaged