Rack Mount Installation - Samson Stage v466 Mode D'emploi

Rack Mount Installation

The SR466 receiver can be installed into a standard 19" for transport or permanent installation
using the included rack ears. Follow the simple steps below to rack mount the SR466:
Attached the included RK466 rack ears, by sliding
each rack ear into the groove on either side of the
SR466 until the rack ear locks into place, and is flush
with the front panel.
Position the SR466 receiver into an available rack space and slide in until the rack ears are touch-
ing the rails of the rack case and are aligned with the rack rail holes.
Mount the receiver into the rack, using
the appropriate size rack screws (not
included). To ensure equal tension and
balance when installing the receiver,
you should secure screws in a crisscross
pattern of opposite corners: top left ->
bottom right -> top right -> bottom left.
11
Stage v466: Quad Vocal Wireless System