Assembly; Operation - Ryobi EVERCHARGE P186 Manuel D'utilisation

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the following purposes:
 Power supply for EVERCHARGE
NOTICE:
Use in a well-ventilated area. Do not block power supply
vents. Keep them clear to allow proper ventilation.
NOTE: MAINTENANCE INFORMATION BEGINS ON PAGE 5
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.

ASSEMBLY

OPERATION

tools
™
ILLUSTRATIONS START ON PAGE 6.
4 — English
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
MOUNTING THE POWER SUPPLY
See Figures 1- 2, page 6.
WARNING:
Make sure the power supply is mounted high enough to
prevent unauthorized activation of the tool. Unauthorized
activation of the tool can result in serious personal injury.
 Find desired location indoors, away from any objects that
could block vents on power supply. Locate a wall stud
to securely mount power supply.
NOTE: Do not place the power supply in an area of
extreme heat or cold. It will work best at normal room
temperature.
 You will need two screws (included).
 Use a pencil to mark screw hole placement and install
top screw.
 If your product includes the optional accessory holder,
place the wide portion of the key hole over the head of
the top screw. Slide the holder down until the screw is
inside the narrow portion of the key hole.
NOTE: If you do not wish to install the accessory holder,
skip this step.
 Place the wide portion of the key hole of the power supply
over the head of the top screw.
 Slide the power supply down until the screw is inside the
narrow portion of the key hole.
 Check the orientation of the power supply and install
bottom screw into the screw hole.