Assembly; Operation; Applications - Ryobi EVERCHARGE P180 Manuel D'utilisation

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.

APPLICATIONS

You may use this product for the following purposes:
 Charging EVERCHARGE
Li-ion battery packs installed
NOTICE:
Charge in a well-ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.

ASSEMBLY

OPERATION

tools with RYOBI ONE+
™
™
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
MOUNTING THE WALL CHARGER
See Figures 1- 4, page 7.
WARNING:
Make sure the charger is mounted high enough to pre-
vent unauthorized activation of the tool being charged.
Unauthorized activation of the tool can result in serious
personal injury.
 Find desired location indoors, away from any objects
that could block vents on charger. Locate a wall stud to
securely mount charger.
NOTE: Do not place the charger in an area of extreme
heat or cold. It will work best at normal room temperature.
 You will need two screws (included).
 Use a pencil to mark screw hole placement and install
top screw.
 If your product includes the optional accessory holder,
place the wide portion of the key hole over the head of
the top screw. Slide the holder down until the screw is
inside the narrow portion of the key hole.
NOTE: If you do not wish to install the accessory holder,
skip this step.
18V
™
 Place the wide portion of the key hole of the charger over
the head of the top screw.
 Slide the charger down until the screw is inside the nar-
row portion of the key hole.
 Check the orientation of the charger and install bottom
screw into the screw hole.
4 — English