Safety Rules For Power Supply - Ryobi EVERCHARGE P186 Manuel D'utilisation

SAFETY RULES FOR POWER SUPPLY

WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS. Fail-
ure to follow all instructions listed below, may result in
electric shock, fire and/or serious personal injury.
 Before using power supply, read all instructions and
cautionary markings in this manual, on power supply,
battery, and product using battery to prevent misuse of
the products and possible injury or damage.
 Do not use power supply outdoors or expose to wet
or damp conditions. Water entering power supply will
increase the risk of electric shock.
 Use of an attachment not recommended or sold by
the power supply manufacturer may result in a risk of
fire, electric shock, or injury to persons. Following this
rule will reduce the risk of electric shock, fire, or serious
personal injury.
 Do not abuse cord or power supply. Never use the
cord to carry the power supply. Do not pull the power
supply cord rather than the plug when disconnecting
from receptacle. Damage to the cord or power supply
could occur and create an electric shock hazard. If cord
or power supply is damaged, have the power supply
replaced by an authorized serviceman.
 Make sure cord is located so that it will not be stepped
on, tripped over, come in contact with sharp edges
or moving parts or otherwise subjected to damage or
stress. This will reduce the risk of accidental falls, which
could cause injury, and damage to the cord, which could
result in electric shock.
 Keep cord and power supply from heat to prevent
damage to housing or internal parts.
 Do not let gasoline, oils, petroleum-based products,
etc. come in contact with plastic parts. They con-
tain chemicals that can damage, weaken, or destroy
plastic.
 Always wear eye protection with side shields marked
to comply with ANSI Z87.1. Failure to do so could result
in objects being thrown into your eyes resulting in pos-
sible serious injury.
 An extension cord should not be used unless abso-
lutely necessary. Use of improper extension cord could
result in a risk of fire and electric shock. If extension cord
must be used, make sure:
a. That pins on plug of extension cord are the same
number, size and shape as those of plug on power
supply.
b. That extension cord is properly wired and in good
electrical condition; and
c. That wire size is large enough for AC ampere rating of
power supply as specified below:
Cord Length (Feet)
Cord Size (AWG)
NOTE: AWG = American Wire Gauge
 Do not operate power supply with a damaged cord or
plug, which could cause shorting and electric shock. If
damaged, have the power supply replaced by an autho-
rized serviceman.
 Do not operate power supply if it has received a sharp
blow, been dropped, or otherwise damaged in any
way. Take it to an authorized serviceman for electrical
check to determine if the power supply is in good working
order.
 Do not disassemble power supply. Take it to an au-
thorized serviceman when service or repair is required.
Incorrect reassembly may result in a risk of electric shock
or fire.
 Unplug power supply from outlet before attempting
any maintenance or cleaning to reduce the risk of
electric shock.
 Disconnect power supply from the power supply when
not in use. This will reduce the risk of electric shock or
damage to the power supply if metal items should fall
into the opening. It also will help prevent damage to the
power supply during a power surge.
 Risk of electric shock. Do not touch uninsulated portion
of output connector or uninsulated battery terminal.
 Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If you
loan someone this tool, loan them these instructions also
to prevent misuse of the product and possible injury.
2 — English
25' 50' 100'
16 16 16