Nilfisk Viper CEX410 Manuel Du Propriétaire page 15

WARNING
the plug from the socket-outlet
when replacing parts or
converting the machine to
another function during
cleaning or maintenance.
To keep the machine performing well and
prolong its life time, please perform the
following maintenance procedures.
Daily maintenance
1) Drain and rinse the recovery tank and
solution tank.
2) Check quick couplers and nozzles. Clean if
required (Note: Never use a pointed object to
clean nozzles, only rinse them with hot water)
(refer to F10).
3) Remove float filter from the recovery
tank and clean it with water (refer to F11).
4) Check filling port filter and clean it with
water (refer to F12).
5) Check water pump filter below the
machine and clean it with water (refer to
F13).
6) Check rolling brush and remove any
debris or carpet fibers.
WARNING
power switch and disconnect
the mains plug before check
the rolling brush.
7) Check vacuum shoe and remove any
debris or carpet fibers.
8) Clean machine with a soft after use.
9) Check power cable, extension cord and
hoses for damage before each use of the
machine.
Monthly maintenance
1) Check the rolling brush for any wear and
tear. Replace if necessary.
2) Check hoses and seals to see if there are
damages. Replace if necessary.
: Removing
: Turn off the
13
3) Check the machine for water leaks.
4) Lubricate wheels.
5) Check machine for loose or missing nuts,
screws , bolts and replace if necessary.
6) Check the V-belt for any wear and tear.
Replace if necessary.
Nozzle installation (refer to F14).
1. nozzle base 2. rubber seal ring
3. Spray tip nozzle
After the nozzle is cleaned, the nozzle needs
to be installed on the base. First, install the
rubber ring to the correct position, then
press down and rotate the nozzle for 90
degrees aligning the nozzle in a horizontal
direction, the installation is complete.
Storage
Power cord storage
1) Bind the power cord by cable ties and
stored on the power cord hook (refer to F15).
2) The power cord can also be wound
around the handle tube (refer to F16).
Machine storage
Note: Empty the recovery tank and
solution tank prior to storing the
machine to keep the tanks fresh, and
in case of freezing temperatures.
This machine should be stored
indoors only.
1) Store the machine in an upright position
in a dry area and depress the pedal to keep
the rolling brush off the floor (refer to F17).
2) Fold the handle to the rear of the
machine in order to reduce the storage space
(refer to F18).
3) Remove the recovery tank dome to allow
for air circulation.
Wiring diagram refer to F19
Technical specifications refer to F20
Machine material composition and
recyclability refer to F21
ENGLISH