Installation; Mechanical Assembly; Pneumatic Fitting - Festo ZSB-1/8-B Notice D'utilisation

ZSB-1/8-B
5

Installation

5.1

Mechanical assembly

1. Place the product so that the filter for the breathing opening 4 is not covered.
2. Fasten the product with two M5 screws via the through holes 6 or with two M5 screws via the
fastening thread.
3. Install two 3/2-way push-button valves (
Caution
Any attempt to actuate the push-button valves with only one hand or with an elbow, a
knee or a foot will impede the safety function (
• Make sure the requirements for setting up two-hand push-button switching circuits
as per EN 574 are observed, e.g. by specifying the minimum distance between the
push-buttons.
• If necessary, take into account existing C-standards for your type of machine.
• Implement the measures as per EN 574.
Fig. 4
5.2

Pneumatic fitting

1. Remove the transport covers on the compressed air connections.
2. Connect the tubing with the specified components (
Note
The product will function as intended providing it is set up correctly and if the
exhausting is correct.
• Use the same lengths of tubing between the push-button valves and the two-hand
control unit.
• Secure the hoses to the system to prevent them from moving in an uncontrolled
manner.
• Use only 3/2-way push-button valves.
• The outlet ports 3 must remain open to allow venting of the push-button valves.
Use a suitable silencer if required.
• If required, use a suitable silencer at outlet port 3 of the control block for two-hand
start (
• Replace contaminated silencers if necessary.
Festo – ZSB-1/8-B – 1202NH English
Fig. 2).
www.festo.com/catalogue/zsb).
Fig. 4).
Tab. 1).
17