Safety Conditions; Areas Of Application And Approval By Authorities - Festo ZSB-1/8-B Notice D'utilisation

ZSB-1/8-B
4

Safety conditions

Note
Incorrect handling can lead to malfunctioning.
• Make sure that the specifications in this chapter are always observed.
• Compare the maximum values in these operating instructions with your actual application
(e.g. pressures, temperatures).
• Also observe national regulations and the specifications of standards EN ISO 4414, EN 574 and
EN ISO 13849-1.
• Use a service unit of the MS or D-series from Festo for preparing the compressed air (
• Take suitable measures to ensure the minimum pressure of 4 bar necessary for operation.
A pressure sequence valve of type VD-3-PK-3, for example, is suitable here (
• Remove the packaging except for the adhesive labels on the compressed air supply ports (to
prevent dirt).
• Observe local regulations when disposing of the product and its packaging.
• Use the product in its original status, without any unauthorised
product modifications. The individual components are fixed with
screw locking agent (
4.1

Areas of application and approval by authorities

The product is a safety component as defined in the Machinery Directive 2006/42/EC and carries the CE
mark. Standards and test values, which the product complies with and fulfils, can be found in the
Technical data section (
The product-relevant EU directive can be found in the declaration of conformity.
Certificates and the declaration of conformity for this product can be found at www.festo.com.
16
Fig. 3).
chapter 12).
Fig. 2).
Fig. 2).
Fig. 3
Festo – ZSB-1/8-B – 1202NH English