Extension Tubes; Floor Nozzle - Dirt Devil Vapormate M 388 Mode D'emploi

3 Starting Up
3.1.2

Extension Tubes

3.1.3

Floor Nozzle

NOTE:
The floor nozzle is
delivered with a
separate connector for
packaging reasons.
Assemble the connector
as illustrated.
1.
2.
Assemble the extension hoses if the steam cleaner is to be used to clean
floors or difficult to reach areas. To do this, push the open end of a tube
onto the steam gun. Push it onto the steam gun until the release
button of the steam gun clicks into place (Fig. 6). Add one, two or all
three extension tubes as required.
Fig. 6 Release button
Steam button
Press in the appropriate release button and pull the tubes apart with
a downward movement to take the extension tube off again (Fig. 7).
Attach the floor nozzle to the end of the extension tube. Ensure
that the nozzle clicks into place on assembly (Fig. 8). The floor nozzle
is ideal for cleaning washable wall and floor coverings. It may be
used with or without the cleaning cloth. However, we recommend
using the cloth to protect coverings in the case of sensitive surfaces
such as wood or linoleum. Place the floor nozzle on the cleaning cloth
and secure the overhanging material under the cleaning cloth clips
on the left and right. Press on the inner sides of the yellow holder,
then open the clips and the cleaning cloth can be secured in place
(Fig. 9).
Fig. 8
To take the floor nozzle off again, press in the appropriate release but-
ton (see Fig. 7) and pull the nozzle off with a downward movement.
Fig. 7
Release
button
Fig. 9
7