Publicité
Les langues disponibles
Les langues disponibles
1 Technical data
1.1 Keyboard
Bezeichnung/Designation/
Désignation
Spannungsversorgung/
Power supply/Alimentation
Stromaufnahme/
Current consumption/
Consommation de courant
Lagertemperatur/
Storage temperature range/
Température de stockage
Betriebstemperatur/
Operating temperature range/
Température de fonctionne-
ment
Abmessungen/Dimensions/
Dimensions
1.2 Chip card reader
Bezeichnung/Designation/
Désignation
Kartenleseeinheit/
Card reading unit/
Lecteur de carte
Protokolle/Protocols/
Protocoles
4
2 Certifications
2.1 Hinweis zum GS-Zeichen
Aufgrund der Position der Nulltaste des Nummern-
Wert/Value/Valeur
felds ist die Tastatur für Saldiertätigkeiten, die über-
wiegend blind erfolgen, in Deutschland nicht
+5 V ±5 % SELV
anzuwenden. Eine Tastatur mit nicht-deutscher Tas-
tenknopfbelegung ist in Deutschland aufgrund der Zei-
chenbelegung (DIN 2137 Teil 2) nicht für den
max. 100 mA
Dauereinsatz an Bildschirmarbeitsplätzen zu verwen-
den.
–20 °C ... +60 °C
2.2 Federal Communications
Commission (FCC) Radio Frequency
Interference Statement
0 °C ... +50 °C
Information to the user: This equipment has been
tested and found to comply with the limits for Class B
digital device, pursuant to Part 15 of the FCC Rules.
458 x 195 x 60 mm
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
Wert/Value/Valeur
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
100 000 Steckzyklen/
reception, which can be determined by turning the
insertions/
equipment off and on, the user is encouraged to try to
cycles d'insertion
correct the interference by one or more of the
T=0, T=1, S=8, S=9,
following measures:
S=10
• Reorientate or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Caution: Any changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
2.3 For UL
For use with Listed Personal Computers only!
2.4 VCCI Statement
Publicité
