Fitting The Crankset On To The Frame; Fitting The Bearing To The Frame - Look ZED 3 Manuel

EN
Fitting the crankset on to the frame: since the ZED crankset is monobloc, the left crank will have to
be passed through the frame in order to fit it, as shown in figure 10. The right pedal can be fitted to the
crankset before it is fitted to the frame, which is not the case for the left pedal, which will have to be fitted
once the ZED crankset is correctly fitted to the frame.
• There are no specific tools required to fit the crankset, but it is still recommended to refer to your
specialist LOOK retailer to fit or remove the crankset.
• Before attaching the crankset to the frame, check that the bearings are correctly attached to the
frame (see figures 7 and 8).
• Before attaching the crankset to the frame, check that there are no parts missing from the whole set
that is pre-fitted on the crankset (see figures 1 and 9).
Attention:
• Remove all dust and clean the bearing seats in the bottom bracket with the recommended
lubricant.
• Never wash your bicycle with a pressurized jet. High pressure water, even the water from a
hose pipe, can, despite the gaskets, enter into the bottom bracket and irremediably damage
the components and bearings in the ZED crankset. Wash your crankset when it is attached
to your bicycle. Delicately clean the carbon parts with a soft cloth, water and neutral soap.
• Do not leave the ZED crankset inside a car parked in the sun, nor near to the radiator or any
other source of heat.
Attaching and detaching the bearings in the frame: the ZED 3 crankset requires the 2 bearings to be
fitted directly in the frame. For improved comfort, they are also glued.
To avoid damaging the bearings when attaching and/or detaching, it is strongly recommended to
use specific tools. LOOK has created a tool for retailers. It is therefore essential that these steps are
performed by a specialist LOOK retailer.
Orientation of the frame
for the fitting view
32

FITTING THE CRANKSET ON TO THE FRAME

FITTING THE BEARING ON TO THE FRAME
Mobile section
of the middle
Glueing guide
(help to glue)
Specific
assembly tool
Specific tool
exploded view