Fitting The Chainrings On To The Crankset - Look ZED 3 Manuel

EN
FITTING THE CHAINRINGS
Chainring moun-
ting screw (x5)
It is recommended to fit the LOOK ZED 3 chainrings with the ZED 3 crankset. These LOOK ZED 3
chainrings are developed to be compatible with the different groups and are optimised for weight gain,
gear shifts and rigidity.
However, there is a fittings kit for standard chainrings containing 5 screws and 5 struts and the double or
compact chainrings that match the constraints described below can equip the ZED 3 crankset:
- contain 5 mounting holes
- have an inter-axle distance of 110 mm or 130 mm
- have an effective clamping width of 4 mm for the exterior chainring
- have a perfectly flat exterior surface for the exterior chainring
- have an effective clamping width of 3.5 mm for the interior chainring
- accept the placement of the specific LOOK inter-chainring struts with a width of 3.5 mm
For any other chainrings, such as oval chainrings, please refer to the compatibility table available
from chainring suppliers and on the website www.lookcycle.com.
28

FITTING THE CHAINRINGS ON TO THE CRANKSET

Interior Inter-chainring
chainring
strut (x5)
Exterior
chainring
ZED 3
crankset
Fig 2