Cleaning & Maintenance; Accessories; Environmental Protection; Technical Specifications - Metabo Sr 356 Mode D'emploi

9 Cleaning, Maintenance
Clean the machine regularly. This includes
vacuum cleaning the ventilation louvres on the
motor.
Replacing worn sanding plate (1)
- Remove fixing screws (on lower side of sanding
plate).
- Take off sanding plate.
- For sanding plate (as replacement), refer to the
Accessories chapter.
- Mount sanding plate.
- Refit fixing screws (on lower side of sanding
plate) and tighten.
10 Tips and Tricks
Do not press the device too firmly against the
surface being sanded. This does not improve, but
rather impairs, the sanding performance.
To optimise the extraction performance, empty the
dust bag (11) in good time or replace.
Use a suitable sanding disc to achieve the best
possible work results: Removal of old paint
layers = P 40
Pre-sanding of wood = P 60, P 80
Finishing of wood = P 100, P 120
Sanding of veneers, sealing primer, filler,
paint = P 180, P 240

11 Accessories

Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Perforated sanding discs,
quality finishing for wood
B Perforated sanding discs,
extra quality for wood/metal
C Non-perforated sanding discs,
quality finishing for wood
D Non-perforated sanding discs,
extra quality for wood/metal
E Hole punch
F Perforated sanding plate (as replacement)
G Self-adhesive perforated film with velcro-type
fastening. Before affixing the film, clean the
sanding plate.
H Perforated sanding plate with velcro-type
fastening
I Perforated adhesive sanding discs.
J Dust bag holder (as replacement)
K Dust bag (as replacement)
L Dust bag (material)
M Metabo universal vacuum cleaner
For complete range of accessories, see
www.metabo.com or the main catalogue.
12 Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.

13 Environmental Protection

Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2002/
96/EC on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately
and handed in for environmentally compatible
recycling.

14 Technical Specifications

Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
D = Diameter of support plate
P = Nominal power input
1
P2 = Power output
s = Oscillating frequency at idle speed
0
s = Oscillating frequency at rated load
1
S = Oscillating circuit diameter
m = Weight without mains cable
Vibration total value (vector sum of three
directions) determined in accordance with
EN 60745:
a = Vibration emission value
h
(Surface sanding)
K = Unsafe (vibration)
h
ENGLISH
ENG
11