Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1-10
Storing hose
Stretch hose out and identify ends.
E. Nozzle connector end of hose
F. Trigger
Note: You may find it helpful when storing the hose to refer to the information on the
back of the deep cleaner and on the converter end of the hose.
1-12
K
Wrap hose around hook on upper
handle (J). Press hose into clips on
upper hose holder (K).
Upfront tool storage
1-15
Powered hand tool
The powered hand tool is shipped in a
plastic bag for protection. Remove the
bag before using the tool by first open-
ing tool door.
F
H
G. Solution tube
H. Converter end of hose
1-13
J
K
Wrap hose around lower tool holder and
continue until nozzle connector is near
upper hose holder. Clip hose in place.
1-16
To remove tool (A), pull it down and out-
ward.
To reposition the tool, reverse this proce-
dure.
E
G
1-11
I
H
Start with converter end of hose (H). Fit
converter over tab near tool holder (I).
Press converter firmly to snap in place.
Press solution tube (G) into clip next to
converter as shown.
1-14
Press cord into cord clip on back of
hose holder. Pull cord tight.
1-17
How to reattach tool
cover
The tool cover is designed with a break-
away feature which allows it to snap free
if it is pushed open too far.
To reattach, align hinges of cover with
slots on sides of tool storage area.
Push cover down to secure in place.
Continued
G
5
Publicité
Chapitres
Table des Matières
