Hitachi RAF-25FX8 Mode D'emploi page 68

7. DISCHARGE FRAME
(1) Remove the front panel and the front cover.
(2) Remove the two fixing screws of the discharge frame.
(3) Remove the screw on the rat prevention cover.
(4) Remove the hook that is the fixation of a lower center part of Discharge frame.
(5) Lower the rear side of the discharge frame, remove the tab on the interfit section, and then pull out the discharge frame
towards you.
Discharge frame tab
Fixation hook
8. DISCHARGE FRAME AUTO SWEEP MOTOR
Cabinet
Rat prevention
cover screw
Discharge frame
fixing screws
Auto sweep motor (2)
– 86 –
Interfit hole
Discharge frame tab
Rat prevention cover
Light receiving unit
Auto sweep motor (1)
Gear motor for
lower air deflector