Hitachi RAF-25FX8 Mode D'emploi page 64

3. Remove the front cover
Latch
Screw
Front Panel
①
Push the latch at both sides to open the front panel. Pull out the filter and remove 3 screws.
Upper Louver
Screw
Screw Cap
③ Take off 2 screw caps at the lower part of
the horizontal air deflector and remove 2
screws. Then leave the upper louver in
open position.
4. Install the front cover
Front Cover Fixing Claws (4 places)
Upper Louver
① Set the upper louver in open position.
Latch
Horizontal
Air Deflector
④ Hold both sides of the lower part of front
cover and pull down towards an oblique
direction.
Front Cover
②
Insert the front cover fixing claws
(4 places) to the insertion groove of the
cabinet and put the upper louver through
to the front cover frame.
Front Cover
Cabinet
Claw
Cabinet
Front Cover
Fixing Claws
(4 places)
– 82 –
Front Panel
Screw
② Lift up the front panel and latch the claws
firmly at the lower part of rear of the front
panel.
Then remove 3 screws.
Horizontal
Air Deflector
Lower Flame
③
Put the horizontal air deflector to the
lower part of front cover frame and insert
to the cabinet.
After fixed the front cover, fix back all the
screws in order.
Cabinet