Bar And Chain Combinations; Troubleshooting - Ryobi RY40007 Manuel D'utilisation

Chain specifications: 3/8 in. pitch, low profile narrow kerf, .050 in. chain gauge, 6-tooth drive sprocket.
Length of Bar
18 in.
PROBLEM
Bar and chain running hot and
smoking.
Motor runs, but chain is not
rotating.
This product has a Five-year Limited Warranty for personal,
family, or household use (90 days for business or commercial use).
For warranty details, visit www.ryobitools.com

BAR AND CHAIN COMBINATIONS

Guide Bar Part Number
317105001

TROUBLESHOOTING

CAUSE
Check chain tension for over
tight condition.
Chain oil tank empty.
Oiler is not functioning.
Chain brake is engaged.
Chain tension too tight.
Check guide bar and chain
assembly.
Check guide bar and chain
for damage.
For any questions about operating or maintaining
your product, call the RYOBI Help Line!
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
or call (toll free) 1-800-525-2579.
Chain Part Number
CALL US FIRST
31 - English
682309001
SOLUTION
Tension chain. Refer to Chain Ten-
sion earlier in this manual.
Check oil tank.
Run at half throttle 30 to 45 seconds.
Stop saw and check for lubricant
dripping from the guide bar. If lubri-
cant is present, the chain may be
dull or bar may be damaged. If no
lubricant is on the guide bar, contact
a qualified service center.
Release chain brake. Refer to
Operating the Chain Brake in the
Operation section of this manual.
Retension chain, Refer to Adjusting
Chain Tension earlier in this manual.
Refer to Replacing the Bar and
Chain earlier in this manual.
Inspect guide bar and chain for
damage.
Drive Links
62