Worx WX178.1 Mode D'emploi page 9

Wear protective gloves
Li-Ion battery.Do not dispose of
Li-I on
batteries, Return exhausted batteries
to your local collection or recycling
point
Drilling
Screwdriving
Wood
Metal
Steel pipe
Ceramic tile
Stripped screw
Lock
High speed
Low speed
Lithium-Ion Cordless Drill/Driver
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your local
authorities or retailer for recycling
advice.
xINR18/65-y: Cylindrical lithium
Ion battery cells with max diameter
of 18mm and max height of 65mm;
"x" represents a number cells serial
connected, blank if 1; "-y" represents
a number of cells paralleled
connected, blank if 1.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for driving in and
loosening fasteners as well as for drilling in wood,
metal and plastic.
ASSEMBLY AND
OPERATION
ACTION
BEFORE OPERATION
Removing the Battery Pack
Charging the Battery Pack
Installing the Battery Pack
ASSEMBLY
Bit Lock Adjustment
TM
WARNING: Always ensure the bit is secure
before starting the tool. Damage to the
Chuck or a loose bit may cause possible personal
injury.
NOTE: When the chuck jaws become fully opened
or closed, the clutch will activate, making a clicking
sound. This sound is normal.
If the Bit Lock Switch (12) does not operate, confirm
TM
the battery is charged and depress the trigger briefly.
Keep drill tilted upward when adjusting the chuck to
prevent bit from falling out.
--Inserting the Bits
--Removing the Bits
Assembling the belt hook and
bit clip
9
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B1
See Fig. B2
See Fig.
C1,C2,C3,C4
EN