Troubleshooting - Zavor LUX Manuel D'utilisation

Troubleshooting

If the LUX™ LCD detects an internal error or a wrong connection, it will show
an error code on the display panel and will stop functioning. These codes will
allow you to identify the cause of the error and help you find the solution to the
problem. If the error persists, please call our customer service department for
assistance at 1-855-928-6748.
E1: Internal circuits have disconnected.
Self-help: Call our customers service department for assistance.
E2: The internal sensor has short-circuited or the unit is
overheating.
Self-help: Try to cool the unit by turning it off and unplugging as well
as removing the cooking pot.
E3: Unit is overheating.
Self-help: Try to cool the unit by turning it off and unplugging as well
as removing the cooking pot. If the E3 message persists,
the cooking pot or heating plate may be deformed. You will
need to contact our customer service department.
E4: Pressure switch has malfunctioned.
Self-help: Check the cooking pot for warping. Check the heating plate
for any food residue.
Problem
• Please be advised that the lid can't be opened until the
The lid cannot floating valve drops down.
be opened at • Make sure you turn the regulator to steam until all internal
the end of the pressure is released and the lid opens easily.
cooking cycle • If this occurs frequently, the gasket may need to be
adjusted.
• Close the lid correctly ensuring there is no gap between
Steam is lid and base.
escaping from • Ensure the silicone gasket is clean, free from damage or
the lid cracks and is properly inserted.
• If problem persists, call our customer service department.
• Close the lid correctly ensuring there is no gap between
lid and base.
Self-locking
• Ensure the silicone gasket is clean, free from damage or
pin does not
cracks and is properly inserted.
rise
• Ensure that the self-locking pin can move freely.
• If problem persists, call our customer service department.
Easy Solution
38
• Ensure that the pressure regulator valve is properly
Cooker is not placed in its housing.
getting to • Add more liquid/food to the bowl. There should be a
pressure minimum of 1 cup of food and liquid in total.
• If problem persists, call our customer service department.
• When the lid is locked, ensure the self-locking pin is
properly secured.
• Ensure that the pressure regulator valve is properly
Timer will not
placed in its housing.
count down
• Add more liquid/food to the bowl. There should be a
minimum of 1 cup of food and liquid in total.
• If problem persists, call our customer service department.
Water is • Ensure the cooker is on a flat, level surface and that the
collecting on condensation drip cup is installed on the side of the cooker.
the countertop • Empty the condensation drip cup.
• Ensure that the lid is on the correct position. For Brown
the lid needs to be off. If the lid is closed under these
The unit is
functions the unit will beep and an icon will indicate to
beeping and
open the lid. For all other functions, the lid must be closed.
not turning on
If the lid is open the unit will beep and an icon will indicate
to close the lid.
Floating Valve Installation
Floating valve
Floating Valve
Floating Mini Gasket
Floating Mini Gasket
Figure: Floating valve Installation
Insert the floating valve from the top of the lid and secure it in place with the washer from the
bottom of the lid.
39