Mute Feature; Cleaning And Maintenance - Zavor LUX Manuel D'utilisation

Mute Feature

In the event that you would like to disable all the beeps from the multi-cooker,
you may do so by pressing and holding the ADJUST button until the display
shows the Mute Icon. All beeps, including button presses and unit notification
sounds, will be disabled for the duration of the use.
To unmute the multi-cooker, press and hold the ADJUST button until the Mute
Icon disappears and the unit emits a beep. This will unmute all beeps.
Note: If you mute the multi-cooker and then unplug it after use, this will disable
the mute feature and the until will be unmuted at its next use.

Cleaning and Maintenance

Do not wash any parts of the multi-cooker in the dishwasher except for the
removable cooking pot. Always wash the removable cooking pot thoroughly
after every use, or if it has not been used for an extended period of time.
1. Unplug the multi-cooker and let the unit cool before cleaning.
2. Remove the removable cooking pot and wash with warm soapy water or
in the dishwasher. Hand washing is always recommended. Rinse and dry
thoroughly.
3. Wipe the body of the unit with a clean damp cloth and rinse the lid with
warm water and soap. Do not submerge the multi-cooker or the lid in water.
NOTE: To remove odor from the inside of the lid, clean it with water and
vinegar (1:1 ratio).
4. Remove the condensation reservoir by pulling it down. Wash with warm,
soapy water. Rinse and dry thoroughly. Replace by pushing it back into
place.
5. Turn the lid upside down; grip the silicone gasket and pull up to remove.
Clean the silicone gasket with warm soapy water. Rinse and dry thoroughly.
Replace the gasket by positioning it inside the edge of the lid and pushing
it down. Make sure the groove in the center of the gasket is positioned
around the metal ring on the inside edge of the lid.
NOTE: The silicone gasket must always be properly positioned on the underside
of the lid; otherwise the unit will not work. Check periodically to make sure that
it is clean, flexible, and not cracked or torn. (See "Getting Started" section in
this manual.)
6. If the silicone gasket appears damaged, cracked or torn, do not use the
unit and contact the Zavor Customer Service Department at 1-855-928-
6748 or visit the Zavor website to purchase a new silicone gasket at www.
zavoramerica.com.
7. For optimal performance, the inside of the cooker, in the area under the
removable cooking pot where the temperature sensor and heating pad are
located, must be cleaned after each use. Wipe with a soft damp cloth and
be sure to dry thoroughly.
8. Never use abrasive cleaners or scouring pads to clean any of the parts.
Cleaning the Pressure Regular Knob
36
ALWAYS check that the pressure regulator knob and the pressure safety valves
are in good working order before each use.
1. After the unit has cooled, remove the lid from the multi-cooker.
2. Press down and turn the pressure regulator knob counterclockwise past
STEAM to CLEAN and carefully lift to remove. Look through the removed
knob to make sure there is no particle build-up, and put it under running
water to clean.
3. Turn the lid over and place it on a table top. Pull out the anti-blocking case.
Using a brush or toothpick, check and remove any food or foreign particles
that may be lodged in the pressure discharging tube that is located inside
the anti-block cover. Replace the anti-blocking case pressing it down back
into place.
4. Replace the pressure regulator knob by lining the CLEAN dot with the dot
on the lid of the unit and turning clockwise until it goes into place. The dot
on the base of the pressure regulator should line up with the PRESSURE
or STEAM setting on the pressure regulator knob. If it doesn't, remove the
knob again and try realigning the dots the other way around.
(1) (2)
(5)
(3)
(4)
37