Installation; Initial Startup - Kärcher FC 7 Cordless Manuel Opérateur

Installation

Installing the handle
1. Hold the basic unit firmly.
2. Insert the cable into the guide of the
plastic connector and fix it in place.
3. Insert the handle into the basic unit
as far as it will go, until it audibly
clicks into place. The handle must sit
firmly in the device.
a
b

Initial startup

Charging process
1. Plug the charging cable of the char-
ger into the charging socket on the
device.
a
b
2. Plug the power plug of the charger
into the socket.
The LED indicator lights show the
current charging state of the battery.
● When charging the completely emp-
ty battery, all 3 LED indicator lights
flash one after the other from bottom
to top.
● When the battery is 1/3 charged, the
bottom LED lights up continuously,
the two top LEDs continue to flash.
● When the battery is 2/3 charged, the
two lower LEDs light up continuous-
ly, the uppermost LED continues to
flash.
● The battery is fully charged after 4
hours.
● After the battery has been charged,
the 3 LED indicator lights will remain
lit for 60 minutes. After this period of
time, the LED indicator lights go out.
3. Unplug the power plug for the char-
ger from the socket after charging.
a
4. Pull the charging cable out of the device.
English
4 h
b
9