Kärcher FC 7 Cordless Manuel Opérateur page 17

3
sec
6. The display indicators light up re-
peatedly from top to bottom.
The rinsing process begins and
takes about 2 minutes.
Note
At the beginning of the rinsing process,
the water runs from the fresh water
tank onto the rollers for about 80 sec-
onds. During this time, the device is
noiseless. Only at the end of the rins-
ing process do the rollers begin to turn
for approx. 30 seconds.
7. When the rinsing process is com-
plete, a signal tone sounds and the
display "MAX" (red) lights up.
ca. 2 min
English
8. Press the unlocking button for the
waste water tank and place the de-
vice on the parking station. The
waste water tank remains in the
cleaning station.
Note
If you try to switch the device on again
when the waste water tank is full, the dis-
play "MAX" (red) flashes for 10 seconds.
It is not possible to continue to clean.
9. Push the unlocking button for the
hair filters inwards.
The hair filters come off.
10.Place the hair filters in the cleaning
station.
a
11.Remove the rollers and place them
in the cleaning station.
b
c
17