Miele S185 Mode D'emploi page 8

CAUTION: DISCONNECT THE CLEANER FROM THE OUTLET
BEFORE PERFORMING THE OPERATIONS BELOW
REPLACING THE DUST BAG
1) Push the release
button on the dust
cover as shown, and
pull it forward.
NOTE: If the dust bag is not installed correctly, the dust cover will not close.
We recommend the use of genuine Miele paper bags only; Part # 05294 741 Type Z
FILTER CARE
In addition to the dust bag, the vacuum cleaner
contains two filters; a central filter that protects
the motor (Fig.1) and a HEPA Filter, that removes
particles from the exhausted air (Fig. 2).
The HEPA Filter should be changed every six
months or whenever it becomes dirty. The central
filter should be changed or rinsed out whenever
the HEPA Filter is replaced.
IMPORTANT: Do not forget to re-install the
filters before use.
2) Grip the handle 3) Close dust bag
of the dust bag tab to avoid dust
and pull out. leakage and put it
away.
Fig. 1
4) Install the new
dust bag by placing
the hole over the
exhaust port and
pressing it into
place as shown.
CENTRAL FILTER (Fig. 1)
Part # F03M1000
To remove, slide the central filter forward out of this
housing.
IMPORTANT: If the central filter has been rinsed
out, make sure it is dry before re-installing it.
HEPA FILTER (Fig. 2)
Part # S02Z6000
To change the HEPA Filter, simply remove the
exhaust cover as shown and replace the filter.
– 8 –
5) Replace the dust
cover by inserting
the tab into the body
slot then push the
top of the cover into
place.
Fig. 2