Gas Connection - Electrolux ECCG3672AS Instructions D'installation

36" GAS RANGETOP INSTALLATION INSTRUCTIONS
The maximum supply pressure of 14.0 inches water
column (34.9 Millibars) must not exceed.
WARNING State of California Proposi-
tion 65 Warning:
This product may contain a chemical known to
the State of California, which can cause can-
cer or reproductive harm. Therefore, the pack-
aging of your product may bear the following
label as required by California. For more infor-
mation go to www.P65Warnings.ca.gov
Propane gas installation
The propane gas tank must be equipped with its
own high pressure regulator. In addition, the regula-
tor supplied with this unit must also be used. The
appliance is shipped from the factory for use with
natural gas. It must be converted for use with pro-
pane. The conversion must be done by a qualified
technician or installer. This appliance has been certi-
fied for safe operation up to a height of 10,000 ft.
Exception: To use it with propane gas, the appliance
must be converted in accordance with the propane
conversion instructions.
For Massachusetts installations:
• Installation must be performed by a qualified or
licensed contractor, plumber or gas fitter qualified
or licensed by the state, province or region where
this appliance is being installed.
• Shut-off valve must be a "T" handle gas cock.
• Flexible gas connector must not be longer than
36 inches (0.9 m).
Installer - show the owner where the gas shut-off
valve is located.

Gas connection

The appliance is shipped from the factory for use
with natural gas at a pressure of 5" of water column.
When checking if the regulator is working properly,
the inlet pressure must be at least 1" greater than
the operating (manifold) pressure above. When
used with natural gas, the pressure supplied to the
regulator must be between 6" and 10.5" of the water
column. To convert the appliance to propane gas
see "Conversion to Propane gas (LPG)". The con-
version must be done by a qualified technician or
installer. Use a flexible gas pipe with a length of at
least 5 ft - 1.5 m. The gas inlet to the unit is located
at the back right of the appliance.
Install the pressure regulator (supplied with the unit)
on the gas inlet. Install the gasket (supplied with the
unit) between the inlet and the regulator. Position
the regulator so that the cap D is easily accessible.
Tighten the nut on the gas inlet so that it is hand tight
plus 1/3 turn. Connect the gas pipe to the regulator
using Teflon tape or pipe-joint compound (resistant
to propane gas and natural gas).
Turn so that it is hand tight plus 1/3 turn. Do not
exceed 1 turn for alignment, to prevent possible
damage to the gas pressure regulator.
1 Gas inlet (attached to the appliance).
2 Gasket.
3 Pressure regulator.
CAUTION
Do not allow regulator to rotate on
pipe when tightening fittings.
WARNING
Do not attempt to adjust the pres-
sure regulator, except when converting to propane.
Adjustments could lead to leaks or cause incorrect
gas pressure being supplied to the appliance.
9