Hach ORBISPHERE 32301 Manuel D'utilisation De Base page 3

Table of Contents
1 Specifications on page 3
2 General information on page 3
3 Oxygen and ozone sensor cleaning
Section 1 Specifications
Specifications are subject to change without notice
Specification
Power supply
Internal fuses
Overvoltage category II
Ambient temperature
Relative humidity
Altitude
EMC requirements
Korean registration
CE compliance
Section 2 General information
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.
2.1 Safety information
The manufacturer is not responsible for any damages due to misapplication or misuse of this product including,
without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extent
permitted under applicable law. The user is solely responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.
on page 6
Details
120 or 230 Vac @ 50/60 Hz, 10 VA
F1 = 100 mA (230V) / 250 mA (120V)
F2 = 630 mA
0 to 40°C (32 to 104°F)
Up to 80%
< 2,000 meters (6,562 feet)
EN61326-1: EMC Directive
User Guidance for EMC Class B Equipment
가정용을 포함하는 EMC 등급 B 장치에
대한 사용자 지침
사용자안내문
B 급 기기 ( 가정용 방송통신기자재 )
이 기기는 가정용 (B 급 ) 전자파적합기기로서 주로 가정에서 사용하는 것을 목적으로 하
며 , 모든 지역에서 사용 할 수 있습니다.
EN61010-1: LVD Directive
4 Hydrogen sensor servicing
5 Circuit testing functions
N O T I C E
on page 8
on page 10
English 3