Publicité
Les langues disponibles
Les langues disponibles
CoNNeCtING A vACuum CLeANeR to
tHe tooL (FIGuRe b)
- Slide vacuum nozzle (8) into the dust
extraction port (5) as shown.
b
USE
WARNING: to reduce the risk of
injury, never use the tool when the saw
shoe is loose or removed.
AdjustING tHe sHoe pLAte FoR
beveL Cuts (FIGuRe C)
The shoe plate can be set to make either a
straight cut or a left or right bevel cut at an
angle of 45°.
- Loosen the two screws (9).
- Pull the shoe (4) forward, rotate the shoe
to the left or right and push it back into the
45° location.
- Tighten the two screws.
To reset the shoe plate for straight cuts:
- Loosen the screws.
- Pull the shoe forward, rotate to the center
and push it back into the 0° location.
- Tighten the two screws.
C
switching on and off
- To switch the tool on, press the variable
speed switch (1). The tool speed depends
on how far you depress the switch.
- For continuous operation, press the
lock-on button (2) and release the variable
speed switch. This option is available only
at full speed.
- To switch the tool off, release the variable
speed switch. To switch the tool off, when
in continuous operation, press the variable
speed switch once more and release it.
How to use the sightline
Feature (figure d)
- Use a pencil to mark the cutting line.
- Position the jig saw over the line (10).
Viewing from directly above the jig saw the
line of cut can be easily followed.
D
5
8
9
®
10
HINTS FOR OPTIMUM USE
General
- Use a high speed for wood, a medium
speed for aluminum and PVC and a low
speed for metals other then aluminum.
sawing laminates
As the saw blade cuts on the upward
stroke, splintering may occur on the
surface closest to the shoe plate.
- Use a fine-tooth saw blade.
- Saw from the back surface of the workpiece.
- To minimize splintering, clamp a piece of
scrap wood or hardboard to both sides of the
workpiece and saw through this sandwich.
sawing metal
WARNING: do not use a vacuum when
cutting metal. Metal filings will be hot and
may cause a fire.
- Be aware that sawing metal takes much
more time than sawing wood.
- Use a saw blade suitable for sawing
metal.
- When cutting thin metal, clamp a piece
of scrap wood to the back surface of the
workpiece and cut through this sandwich.
- Spread a film of oil along the intended
line of cut.
Rip Fence
Ripping and circle cutting without a pencil
line are easily done with a rip fence and
circle guide (available at extra cost).
Attaching Rip Fence (figure e & F)
- Insert rip fence into slots of shoe with the
cross bar (11) facing down as shown in
figure E.
- Place screw (12) into hole in bottom of
shoe.
- Align clamp bar (13) over screw with
lipped edge facing down and pointing
towards the rear of the saw.
- Using a phillips screwdriver, run the
screw into the threaded hole in the bar
clamp as shown in figure F.
- Adjust to width of cut and tighten screw.
E
12
F
5
13
11
Publicité
