Publicité
Les langues disponibles
Les langues disponibles
• ANSI Z87.1 eye protection (CAN/CPA
Z94.3),
• ANSI S12.6 (S3.19) hearing
protection,
• NOSH/OSHA respiratory protection.
WARNING:
Use of this tool can
generate and/or disperse dust, which
may cause serious and permanent
respiratory or other injury. Always use
NIOSH/OSHA approved respiratory
protection appropriate for the dust
exposure. Direct particles away from face
and body.
CAUTION:
Wear appropriate hear-
ing protection during use. Under some
conditions and duration of use, noise from
this product may contribute to hearing loss.
SAvE THESE
INSTRUCTIONS
SYMbOLS
The label on your tool may include the
following symbols. The symbols and their
definitions are as follows:
V ..................volts
A ..................amperes
Hz ................hertz
W .................watts
min ..............minutes
or AC ......alternating current
or DC ...direct current
n o ................no load speed
FUNCTIONAL DESCRIPTION
1. Variable speed switch
2. Lock-on button
3. Saw blade locking lever
4. Shoe
5. Dust extraction port
ASSEMbLY
WARNING: Laceration Hazard. Before
attempting any of the following operations,
make sure that the tool is switched off and
unplugged and that the saw blade has
stopped. Used saw blades can be hot.
FIttING tHe sAW bLAde (FIGuRe A)
- Hold the saw blade (6) as shown, with
teeth facing forward.
- Push the locking lever (3) away from the
shoe (4).
................Class I Construction
(grounded)
................earthing terminal
...............safety alert symbol
................Class II Construction
(double insulated)
.../min or rpm...revolutions or
................Read instruction manual before use
.................Use proper eye protection
................Use proper hearing protection
................Use proper respiratory protection
SFPM ......... surface feet per minute
SPM ............ Strokes per minute
• When using an extension cord, be sure
to use one heavy enough to carry
the current your product will draw. An
undersized cord will cause a drop in line
voltage resulting in loss of power and
overheating. The table shows the correct
size to use depending on cord length and
nameplate ampere rating. If in doubt, use
the next heavier gauge. The smaller the
gauge number, the heavier the cord.
Minimum Gage for Cord Sets
volts
120V
0-25
240V
0-50
AmpereRating
More
Not more
Than
Than
0
- 6
18
6
- 10
18
10 - 12
16
12 - 16
14
3
- Insert the shank of the saw blade into the
blade holder (7) as far as it will go.
- Release the lever.
A
7
3
4
reciprocation per minute
Total Length of Cord in Feet
26-50
51-100
101-150
51-100 101-200
201-300
American Wire Gage
16
16
16
14
16
14
12
Not Recommended
2
1
5
4
6
14
12
12
Publicité
