Two-Thread Serging - Janome 1110DX Pro Livret D'instructions

Two-Thread Serging

* In case of two-thread serging, use one needle thread and the lower looper thread. Remove other threads.
w
y
u
q
e
(A)
r
t
o
i
To attach the spreader
Put the tip of the spreader into the hole on the upper
looper, and slide the spreader down into the holder.
q Spreader
w Upper looper
e Holder
To remove the spreader
Pull tab A on the holder toward you lightly. Push the
bottom of the spreader up and pull it out.
For standard two-thread serging, set the machine as
illustrated.
r Lower looper pre-tension setting silder
(STD. position)
t Changeable thread guide (lower position)
Standard two-thread serging is as illustrated.
y Wrong side of fabric
u Needle thread
i Right side of fabric
o Lower looper thread
32