Pin Tucking; Sewing - Janome 1110DX Pro Livret D'instructions

w
1
2
4
5
6

PIN TUCKING

Refer to page 74 (Narrow Hemming) for thread
*
tension balance adjustment.
1
1 Pin tucking
Thread and Fabric
Fabric
Light to
Medium
Fabric
Machine Setting
1 Remove the needle on the left-hand side
2 Upper knife : Down
3 Lower looper pre-tension setting slider : STD
4 Changeable thread guide : 3/4
e
r

Sewing

Turn off the power switch.
Remove the needle on the left-hand side.
3
Deactivate the upper knife.
Turn on the power switch, then sew the folded edge while
1
guiding along the guide line.
1 Folded edge
2 Guide line on the needle plate
3 Right needle position line on the presser foot
2
4 Left needle position line on the presser foot
5 Right side of fabric
Open the fold flat and press the pin tucks to one side.
NOTE: After you finish sewing,return the upper knife
6 Pin tucking
84
Thread
Needle thread on the
right
Upper looper thread
Lower looper thread
to rhe original position.
Synthetic : No. 60~80
Silk : No. 50~80
Synthetic : No. 60~100
Silk : No. 50~100