Changing Needle; Raising Or Lowering The Presser Foot - Janome 1110DX Pro Livret D'instructions

4
5
3
1
6
2
1
2
4
2
1
1
18

Changing Needle

Turn off the power switch and unplug the machine.
Raise the needle to its highest position.
Then loosen the left or right needle clamp screw for the
needle you are going to remove.
1 Needle clamp screw on the left
2 Needle clamp screw on the right
* Use HA-1SP #14 Needle or #11.
To attach the needle on the right :
Insert a new needle into the needle clamp with the flat
side to the back until the top of the needle touches the
stopper pin, then tighten the needle clamp screw on the
right.
To attach the needle on the left :
Insert a new needle into the needle clamp with the flat
side to the back until the top of the needle touches the
edge of the needle bar, then tighten the needle clamp
screw on the left.
* When the needles are set correctly, the left
needle is higher than the right one.
* Use HA-1SP #14 Needle or #11.
1 Needle clamp
2 Needle
3 Needle stopper pin
4 Edge of needle bar
5 Needle clamp screws
6 Flat side to the back
* Do not use any needle which is bent or blunt.

Raising or Lowering the Presser Foot

By raising or lowering the presser foot lifter, the presser
foot goes up or down.
* While in operation, keep the presser foot lowered
except when threading the machine or test running
without threads.
Thread tension will be released when the presser foot
lifter is raised.
1 Presser foot
2 Presser foot lifter