Braun ThermoScan 5 Mode D'emploi page 7

How to use your Braun ThermoScan
1
2
Push the Power button
During an internal self-check, the display shows all
segments. Then the last temperature taken will be
displayed for 5 seconds.
The lens filter indicator will
3
blink to signal one is needed.
To achieve accurate
measurements, make sure a
new, clean lens filter is in place
before each measurement.
Attach a new lens filter by
pushing the thermometer probe straight into the lens filter inside the box and then pulling out.
Note: The Braun ThermoScan will not work unless a lens filter is attached.
The thermometer is ready to take a temperature when the display looks like the images below.
1. Guyton A C, Textbook of medical physiology, W.B. Saunders, Philadelphia, 1996, p 919
2. Guyton A C, Textbook of medical physiology, W.B. Saunders, Philadelphia, 1996, p 754-5
3. Netter H F, Atlas of Human Anatomy, Novartis Medical Education, East Hanover, NJ, 1997, pp 63, 95.
Remove the
thermometer
from the
protective
case.
.
Remove
protective
cap.
5