Braun ThermoScan 5 Mode D'emploi page 10

Night light feature
This thermometer includes a convenient night light
to illuminate the display in a dim environment.
The light will turn on when you press any button. It
will stay on until the thermometer is inactive for up
to 15 seconds even after temperature is taken.
Changing the temperature scale
If you wish to change the temperature scale of your thermometer:
1
Make sure the thermometer is turned off.
Press and hold down the Power button
2
the display will show this sequence: ° C / SET / ° F / SET ...
Release the Power button
3
There will be a short beep to confirm the new setting, then the thermometer
is turned off automatically.
Care and cleaning
The probe tip is the most delicate part of the thermometer. It must be
clean and intact to ensure accurate readings. If the thermometer is ever
accidentally used without a lens filter, clean the probe tip as follows:
Very gently wipe the surface with a cotton swab or soft cloth moistened
with alcohol. After the alcohol has completely dried out, you can put a new
lens filter on and take a temperature measurement.
If the probe tip is damaged, please contact Consumer Relations.
Use a soft, dry cloth to clean the thermometer display and exterior. Do not use abrasive cleaners.
Never submerge this thermometer in water or any other liquid. Store thermometer and lens filters
in a dry location free from dust and contamination and away from direct sunlight.
Additional lens filters (LF 40) are available at most stores carrying Braun ThermoScan.
Replacing the batteries
The thermometer is supplied with two 1.5 V type AA (LR 06) batteries.
For best performance, we recommend Duracell
1
Insert new batteries when the battery symbol appears on the display.
Open the battery compartment. Remove the batteries and replace with new
2
batteries, making sure the poles are in the right direction.
3
Snap battery door into place.
To protect the environment, dispose of the product and empty batteries at
your retail store or at appropriate collection sites according to national or
local regulations.
8
. After about 3 seconds
when the desired temperature scale is shown.
alkaline batteries.
®
15 sec 15 sec