Publicité
Les langues disponibles
Les langues disponibles
The ME equipment is intended for use in the electromagnetic environment specified below.
The customer or the user of the ME equipment should ensure that it is used in such an environment.
Emissions Test
RF Emissions
CISPR 11
RF Emissions
CISPR 11
Harmonic emissions IEC
61000-3-2
Voltage fluctuations /
flicker emissions
Non-Life Support Equipment Separation Distance Calculation (3Vrms / 3V/m compliance)
Rated maximum output power of
transmitter (W)
0.01
0.1
1
10
100
The ME equipment is intended for use in the electromagnetic environment specified below.
The customer or the user of the ME equipment should ensure that it is used in such an environment.
Immunity test
Electrostatic discharge (ESD)
IEC 61000-4-2
Radiated RF
IEC 61000-4-3
Conducted RF
IEC 61000-4-6
Electrical fast transient
IEC 61000-4-4
Surge
IEC 61000-4-5
Power frequency magnetic field
IEC 61000-4-8
Voltage dips, short interruptions
and voltage variations on power
supply input lines
IEC 61000-4-11
Guidance and manufacturer's declaration – electromagnetic emissions
Compliance
The ME equipment uses RF energy only for its internal function. Therefore, its RF emissions are
Group 1
very low and are not likely to cause any interference in nearby electronic equipment.
Class B
Not Applicable
Not Applicable
150 kHz to 80 MHz in ISM bands
3,5
d = [
] P
V
1
0.12
0.37
1.17
3.69
11.67
Guidance and manufacturer's declaration – electromagnetic immunity
IEC 60601 test level
±6kV Contact
±8kV Air
3 V/m 80MHz to 2.5GHz
3Vrms 150kHz to 80MHz
±2kV power line
±1kV I/O lines
±1kV differential
±2kV common
3 A/m
>95% dip 0.5 cycle
60% dip 5 cycles
70% dip 25 cycles
95% dip 5 sec.
Electromagnetic environment – guidance
The ME equipment is
solely battery powered.
Separation distance according to frequency of transmitter (m)
80 MHz to 800 MHz
3,5
d = [
] P
E
1
0.12
0.37
1.17
3.69
11.67
Compliance level
Complies
Complies
Not Applicable
(no electrical cabling)
Not Applicable
Not Applicable
Complies
Not Applicable
Complies
800 MHz to 2.5 GHz
7
d = [
] P
E
1
0.23
0.74
2.33
7.38
23.33
Electromagnetic environment – guidance
Floors should be wood, concrete, or ceramic tile. If
floors are covered with synthetic material, the
relative humidity should be at least 30%.
Field strengths outside the shielded location from
fixed RF transmitters, as determined by an
electromagnetic site survey, should be less than 3
V/m.
Interference may occur in the vicinity of equipment
marked with the following symbol:
Separation distance calculation provided above. If a
known transmitter is present the specific distance
can be calculated using the equations.
The ME equipment
is solely battery powered.
Power frequency magnetic fields should be at levels
characteristic of a typical location in a typical
commercial or hospital environment.
The ME equipment
is solely battery
powered.
Publicité
