Knick BasicLine BL 570 Mode D'emploi page 17

2. Intended Use
The BasicLine BL 570 universal isolator is used for galvanic isolation and
conversion of signals in the range from ±20 mV to ±200 V and ±0.1 mA
to ±100 mA. DIP switches allow selection of calibrated input and output
signals. The preset measuring ranges do not have to be fine adjusted. Other
transmission ranges are infinitely adjustable within the ranges mentioned
above using potentiometers. Signal transmission is linear. The universal power
supply allows operating the devices with 24 V DC or with 100 ... 230 V AC.
Connection is made using screw clamp terminals.
Warning against misuse
Do not operate the device outside the conditions specified by
the manufacturer, as this might result in hazards to operators or
malfunction of the equipment.
The system installer is responsible for the safety of the system in which
the device is integrated.
BasicSoft SW 113 Adjustment Tool
Our BasicSoft SW 113 software tool is available for easier adjustment.
Download at www.knick.de or ask for a CD.
17