Publicité
Les langues disponibles
Les langues disponibles
Remote Control Instructions
Control Buttons
1) Power Switch
2) Mode
3) Fan Speed
4) Used to increase or decrease the temperature to
select a suitable operating temperature setting.
5) Lock: Prevents the remote control settings from
being inadvertently being changed.
6) Restore remote control default settings.
7) TIMER-ON: Used to initiate the AUTO-ON (start)
timer and adjust Timer On settings forward
(0.5/1h)
8) TIMER-OFF: Used to initiate the AUTO-OFF
(stop) timer and adjust Timer Off settings forward
(0.5/1h)
Electronic
Display
1
2
3
6
TEMP.(°C)
To operate the hand held remote control will require
two "AAA" Alkaline batteries (included).
Batteries should be replaced when:
a) No signal (beep) is heard when attempting to
program the main unit.
b) The main unit does not respond to a command
issued by the remote.
Battery replacement:
1. Slide the rear cover on the remote in the general
direction of the arrow. Continue pulling (gently) until
the cover seperates completely from the unit.
2. Insert (2) batteries (AAA) following the same ori-
entation (polarity) depicted inside the battery cham-
ber (+/-).
3. Re-install rear cover.
4. If the remote control will not be used for extend-
ed periods of time (vacations, etc.), batteries should
be removed.
The remote operates within a range of 8 meters
(26 ft.) from the receiver located inside the main
unit. Any obstruction between the receiver and
remote may cause signal interference, limiting the
ability to program the main unit.
Note:
4
•
Remote sets/shows °C only.
7
5
Publicité
