GAUI 500X-S Notice D'emploi page 39

All manuals and user guides at all-guides.com
4. Leaving the programming mode
If the controller is in programming mode, wait until menu item 8 is acoustically displayed. Then slide the throttle control
lever from the full throttle position to the bottom-most position (motor off) within 3 seconds of the sound signal. Depending
on cell number, 2 – 3 brief sounds are emitted, followed by a slightly longer sound. The controller is now ready for operation.
After activation of the factory settings, the controller then also leaves the programming mode.
Once the controller is in setting mode and you have stored a new value, pull the throttle control lever back to the bottom
position (motor off) right after the confirmation sound sequence. Depending on cell number, 2 – 3 brief sounds are emitted,
followed by a slightly longer sound. The controller is now ready for operation.
39