Sauna Heater Stones; Heating The Sauna - Helo ROCHER DE Manuel Produit

2.4 Sauna heater stones

Quality stones meet the following requirements:
- Sauna stones should withstand heat and heat variation caused by vaporisation of the water
thrown on the stones.
- Stones should be rinsed before use in order to avoid odour and dust.
- Sauna stones should have an uneven surface to supply a larger surface for the water to evaporate from.
- Sauna stones should be large enough, measuring about 100–150 mm to allow good ventilation between
the stones. This extends the useful life of the heating elements.
- Sauna stones should be piled sparsely in order to enhance ventilation between the stones. Do not bend
the heating elements together or against the frame.
- Rearrange the stones regularly (at least once a year) and replace small and broken stones with new,
larger stones.
- Stones are piled so that they cover the heating elements. Do not, however, pile a large heap of s
tones on the heating elements. For a sufficient amount of stones refer to Table 2 on page 9. Any small
stones in the package of stones must not be piled on the sauna heater.
- The warranty does not cover defects resulting from poor ventilation caused by small and tightly packed
stones.
- Structural clay tiles are not allowed. They may cause damage to the sauna heater that will not be
covered by the warranty.
- Do not use soapstone as sauna rocks. Any damages resulting from this will not be covered by the stove
warranty.
- Do not use lava stone as sauna rocks. Any damages resulting from this will not be covered by the stove
warranty.
- DO NOT USE THE HEATER WITHOUT STONES.
2.5 Accessories for Rocher sauna heater
Integration flange, soapstone
Integration flange, frosted glass
Led Drive optical fibre light

2.6 Heating the sauna

Before turning the sauna heater on, make sure the sauna room is suitable for taking a sauna bath. When heated
for the first time, the sauna heater may emit some odour. If you detect any odour while the sauna heater warms
up, disconnect the sauna heater briefly, and air the room. Then turn the sauna heater back on.
The sauna heater is turned on from the control panel that has controls for the heating temperature and time.
You should turn the sauna heater on roughly an hour before you plan to take a sauna bath, so that the stones
have time to heat up properly and the air warms up evenly in the sauna room.
Do not put any objects on the sauna heater. Do not dry clothes on the sauna heater or anywhere in its
vicinity.
EAN 6416976384299
EAN 6416976384374
EAN 6416976384893
6