Troubleshooting - Pit Boss PB100P Instructions Et Utilisation

Proper cleaning, maintenance and the use of quality fuel will prevent common operational
problems. When your Pit Boss grill is operating poorly, or on a less frequent basis, the
following troubleshooting tips may be helpful.
For FAQ, please visit www.pitboss-grills.com and click SUPPORT. You may also contact
your local Pit Boss authorized dealer or contact Customer Service for assistance.
WARNING: Always disconnect the gas cylinder prior to opening
the grill for any inspection, cleaning, maintenance or service work.
Ensure the grill is completely cooled to avoid injury.
PROBLEM CAUSE
Burner Will No Gas Flow
Not Light
Obstruction In
Valve
Faulty
Regulator
Regulator
Valve Is Off
Obstructed
Burner Tube,
Burner Ports
Ignitor Failure
Faulty Burner
Burner Will No Gas Flow
Not Stay Lit

TROUBLESHOOTING

SOLUTION
Check gas fuel connection, and ensure it is open. Increase
flow on regular, or replace gas cylinder if empty.
Check connection port from the firebox to the
regulator, and ensure there is no obstruction.
Regulator assembly needs to be replaced. Contact
Customer Service for a replacement part.
Check the regulator valve connection to the gas
cylinder. Remove, then reinstall. Perform leak test.
Check burner tube and burner ports for spider webs
or other obstructions. Follow Care and Maintenance
instructions to clean the burner tube.
Press the igniter button until a loud click is heard.
Repeat until burner lights, or check for proper
positioning of ignitor, and notice if the electrode is
producing a spark; the spark should be visible and
jump from the ignitor to the burner. If there is no
spark, adjust the electrode to slightly bending a little
closer or further away from the burner. If wet, allow
electrode to air dry, or dry with a clean cloth or blow
dryer. If igniter still fails, igniter needs to be replaced.
Contact Customer Service for a replacement part. Use
match for manual lighting of the burner.
Burner needs to be replaced. Contact Customer
Service for a replacement part.
Check gas fuel connection, and ensure it is open.
Replace gas cylinder if empty.
17