EINHELL KSS 12 Mode D'emploi Et Instructions D'entretien page 4

Anleitung KSS 12 08.02.2002 10:56 Uhr
GB
Dear Customer,
Before operating the hammer-action screwdriver for
the first time, please read these instructions and
observe the information provided with regard to its
operation and maintenance.
Please keep these instructions near the tool at all
times.
1. Items supplied
1 screwdriver with hammer action, 12 V/DC
1 plastic carrying case
Set of drive bits size 14, 17, 19 and 21 mm
(one of each)
2. Technical data
Max. loosening torque
Operating voltage
Current rating
Working range (max. thread size)
Sound power level L
WA
Vibration
Square drive mount
Weight
Please note:
Wear proper protective clothing whenever you
work with the hammer-action screwdriver.
Please observe the safety instructions.
3. Features
4
3
1
4
Seite 4
Item Description
1 ON/OFF switch
2 Reversing switch
3 LED
4 Square drive mount (mounting shaft)
5 12V connecting plug with internal fuse
4. Proper use
The hammer-action screwdriver is a handy DC tool
which can be powered from the 12 volt cigarette
lighter socket of an automobile. It is especially
suitable for use in vehicle servicing, e.g. tightening
and loosening screws for changing tires, etc.
Repairs and servicing of the tool should only be
carried out by authorized professional workshops.
320 Nm
5. Safety instructions
12 V / DC
12 A
Practise these safety precautions to protect yourself
M14 and your surroundings from accident hazards.
80 dB(A)
Use the hammer-action screwdriver only as it is
2 intended.
3.1 m/s
Keep tools out of the reach of children.
1/2"
Only begin work if you are well-rested and not
1.7 kg
distracted.
Disconnect the tool from the power supply before
beginning any trouble-shooting or maintenance
work.
Use only original spare parts.
Never run the tool at full idling speed with no load
for an extended time.
Wear protective clothing whenever you work with
the screwdriver.
Wear ear protection and gloves!
6. Putting into operation
Fit the required drive bit onto the square drive mount.
Set the hammer-action screwdriver to the correct
direction of rotation.
2
R = reverse (anticlockwise) to loosen screws
F = forward (clockwise) to tighten screws
5
Apply the drive bit to the screw head and press the
ON/OFF switch.