Quickie Nitrum Notice D'utilisation page 16

Height-adjustable backrest
The backrest may be set to various back heights, in 25 mm
increments. The adjustment ranges are 250 - 300 mm, 300 -
350 mm, 350 - 400 mm and 400 - 450 mm. Release the screw
(1) and set the backrest to the desired height. Tighten up the
screws again to 5Nm. (Fig. 4.24)
Fig. 4.24
16
Adjusting the backrest upholstery
Adjust the tension of the backrest´s top-belt
- Tear both velcroed halves of the top belt apart (Fig.4.25)
- Tension the top-belt or remove tension. Once the desired
strain is set, velcroe both halves back together
- In case of the top-belt laterally protruding over the push-
handles, the belt can be cut to size with a pair of scissors.
Cut the belt between the grey stitchings. The stitching will
prevent the belt from fraying, Melt the cutting edge of the
belt for additional fray-protection. (Fig.4.26)
Fig. 4.25
1
Fig. 4.26
Note for wheelchairs with fold-down push-handles
Do not use the velcro-laces around the push-handles to set the
strain of the belt (Fig.4.27). Those must be velcroed to the top-
belt using their full length.
Fig. 4.27
Nitrum / Nitrum Hybrid Rev.B